The Mistral has blown in

I picked up a much adapted Holdsworth last week as it’s previous elderly owner had finally hung up his cycling jersey .

IMG_20190720_110347653

 

He had swapped the drop bars for a set of flats , replaced the original crankset for an mtb inspired triple item along with matching Shimano sis thumb operated gear shifters and mechanisms .

IMG_20190723_081649189

 

The only change I have made was to replace the steel rimmed wheels for a set of alloy rimmed ones with new tyres . I also cleaned and lubed the chain as it looked like it needed doing and fitted one of my selle smp saddles .

IMG_20190720_110353918

The only other thing I have done is to use it for about 60 miles in its first week it has done a mixture of daily commutes and a nice Saturday morning pleasure ride .

IMG_20190727_071300055

 

 

 

Ribble Audax bar swap

I picked up this very lightly used Ribble a few weeks back . The previous owner claimed to have only used it for about 100 miles .

IMG_20190526_151833362

As you can see it had originally been built with flat bars and brifters that only allowed 12 of the 14 gears to be selected due to a mismatch of components , I tried to sort this but couldn’t find those extra pair of gears .

IMG_20190528_080735507

Whilst trying it out a couple of other issues became apparent , it’s front caliper Allen key bolt was only just reaching the caliper threads and the headset spacer arrangement wasn’t tensioning the headset bearings .

Once this pair of issues was sorted I decided to swap the flat bars for a set of drops. First job was to replace the original rear wheel and fit a new 8 speed cassette and a set of NOS Claris sti units .

IMG_20190719_054845395

I had initially fitted a riser stem but soon swapped that out for a flat one . and started to cable up the gears and brakes .

IMG_20190719_054837327

After a bit of setting up it was time for some test miles to see what it felt like . All was good so next job is to fit the matching fr wheel and to sort out the squeaky fr mudguard .

Then once I am happy with everything I can finish it off with some new bar tape .

 

Triban 500 refresh

I Picked  up this Triban 500 up a few weeks ago .

IMG_20190617_203134066

It has seen a degree of abuse and neglect since it rolled out of Decathlon .

 

 

IMG_20190618_052929037

Overall it wasn’t in too bad a condition and just needed a refresh .

 

First job was to lose the odd and incorrect wheels and replace them with a better set I had lying around .

IMG_20190621_055705033.jpg

Next job was to replace the chain and cassette as the chain registered over 75% wear .

 

I than gave it some miles to find any other faults  .  First one that came to light was that after anything more than a mile the saddle would start to move on its clamp , next up was to replace the brake pads as they were getting a bit thin , and then there was a bit of tidying up of the headset spacer arrangement by losing the lower clamp and fitting a couple of wider washers rather that the multiple narrow ones .

IMG_20190706_070108156.jpg

 

So after a week of commuting and making some adjustments I thought it was time to give it a proper ride .

IMG_20190706_063947404.jpg

 

Only a total of 35 miles but they were all very nice ones which the bike behaved well and did everything it was asked to do without any issues .